Notice that one of the port number is for the hands and the other is for the body. Remember the IP Addresses and Port numbers. Click the Gear icon button of the iClone tile-block.Is launched, click the Live Stream On button. After your actors have put on the suit and Smartsuit studio.When the screen shows Ready, then the calibration is finished and you can start to capture the performer's motions.The application starts to countdown, hold your hands in a prayer gesture, as shown in the illustration, until the calibration finishes.Click the Perform Calibration pose on all live inputs button at the top of the application.It is because the Hands Calibration has not been performed. As you can see the dummy hands in the 3D window appears incorrectly.Receiver Port: The port that for transferring captured motion data.Receiver IP: The address of the Wifi Server device.Password: Type in the correct password for accessing the wifi domain.WIFI network: Make sure you type in the correct domain name on which the Rokoko SmartSuit, Gloves, AP and computer that Motion Live plug-in are mounted or installed.Click the Settings Applied button and close the panel. Adjust the settings in the next page of the panel.Click the Reuse wifi setup button in the Wifi Setup panel.
Click the Configure your SmartGlove button.Please make sure you have installed or upgraded the Rokoko Profile V 1.19 for Motion LIVE plug-in. Not only can you capture performances by one actor, multiple actors are also allowed. Motion LIVE V 1.1 plug-in supports Rokoko Smartsuit Pro V 1.19 mocap device for hands, which provides a complete hands mocap solution for production. Device Settings - Rokoko Smartsuit Pro V 1.19 (New for V 1.1)
0 kommentar(er)
